Repeater Loopback - Paradyne 7110 User Manual

Repeater Loopback

7110-A2-GB20-00
Repeater Loopback (RLB) loops the signal being sent from the data port back to
the data port. Framing CRCs and BPVs are corrected.
Procedure
To run a Repeater loopback:
1. Position the cursor at the Start command next to Repeater Loopback on the
Network Tests screen.
2. Press Enter.
3. The Start command is changed to Stop. If you want to manually stop the test,
verify that the cursor is positioned at the Stop command.
4. Press Enter. The duration of the test is displayed.
DSU CSU
RLB
DTE
Repeater Loopback cannot be started when any of the following tests are already
active: Data Terminal Loopback, Data Channel Loopback, Payload Loopback.
June 1997
Network
Interface
ALL 1s
496-15077
Testing
5-5