External Device Options For The Management Port - Paradyne 7110 User Manual

Configuration Option Tables

External Device Options for the Management Port

A-16
Table A-6. Management Port Options (3 of 3)
Stop Bits
Possible Settings: 1, 2
Default Setting: 1
Provides the number of stop bits for the Management port.
Stop Bits option appears when Port Type is set to Asynchronous.
1 or 2 – Selects the number of stop bits.
Monitor DTR
Possible Settings: Enable, Disable
Default Setting: Enable
Specifies monitoring of the Data Terminal Ready (DTR) control lead.
Monitor DTR option appears when Port Type is set to Asynchronous.
Enable – Standard operation of the DTR control lead.
Disable – DTR is ignored. Some external device connections may require this setting.
To access the External Device Options screen, follow this menu selection
sequence:
Main Menu Configuration
User Interface External Device
Table A-7. External Device Options (1 of 3)
External Device Commands
Possible Settings: Disable, AT, Other
Default Setting: Disable
Specifies the type of external device commands to be sent out the Management port.
NOTE: The Management port DTR lead is monitored to detect loss of the external
device connection. The external device DSR lead must be connected to the
Management port's DTR lead, via a standard EIA-232 crossover cable, and
the device must be configured to wink DSR on disconnect.
Disable – No external device commands will be sent out the Management port.
No other options in this table will appear.
AT – Standard AT commands are sent out the Management port to control an external
device, such as a modem. When establishing a connection, the AT dial command "ATD"
will precede the phone number from the dial directory.
The next option, Dial-In Access, is available when External Device Commands is
set to AT; no other options in this table will appear.
Other – Commands configured by the user are sent out the Management port.
June 1997
Load Configuration From
7110-A2-GB20-00