Paradyne 3100 Quick Installation

SNMP LAN Adapter for Ethernet Quick Installation
Document Number 3100-A2-GK42-10
October 1997

Installation Steps

Follow these steps to install the SNMP LAN Adapter. See the SNMP LAN Adapter Owner's Manual if you
require more information.
1. Connect the LAN Adapter to your network. You require a 10BaseT or Thinnet cable. This cable is not
included. If you use a Thinnet cable, you must change jumpers inside the LAN Adapter. See the Owner's
Manual.
2. Select one of the two cables provided with the SNMP LAN adapter using Table 1. One end of each cable
is marked LANA. The other end of the cable is marked COM or AUX.
3. Insert the end of the cable marked LANA into the UNIPORT socket of the LAN Adapter. Connect the
other end of the cable into the appropriate port of an SNMP-managed device, using the included DB25
adapter if necessary.
4. Configure the IP address of the managed device. The address must be on the same subnet as the LAN
Adapter.
Managed
Device
Ethernet
Hub
3100-A2-GK42-10
TM
DB25 Adapter
(if required)
AUX
AUX
Cable
8-Wire
Twisted Pair
(not included)
R N
H E
E T
AC Outlet
COM
(connect last)
COM
Cable
or
LANA
LANA
I N
P R
E L
L L
R A
P A
1
r t
T
P o
O R
I P
U N
K
O R
T W
e t
N E
i n n
E T
T h
For Thinnet
LAN only – see
Owner's Manual
October 1997
Power Cord
E R
W
P O
R
T E
Unused
97-15592
1