Paradyne 7110 User Manual page 96

7110-A2-GB20-00
Table A-9. Alarms & Traps Options (2 of 2)
SNMP Trap Disconnect
Possible Settings: Enable, Disable
Default Setting: Enable
Determines if a Management port external device connection is dropped after sending
an SNMP trap.
A call established to send out an ASCII alarm always disconnects automatically if
the call was initiated automatically.
Enable – The external device disconnects after sending out an SNMP trap.
Disable – The external device remains connected and must be disconnected by remote
modem or manually. This allows the NMS to poll the DSU/CSU after receiving an SNMP
trap.
Call Retry
Possible Settings: Enable, Disable
Default Setting: Disable
Specify if an unsuccessful call is retried.
Enable – The call is retried up to five times for each ASCII alarm and each SNMP trap.
The following options, Dial-Out Delay Time (min) and Alternate Dial-Out Directory,
affect the amount of time before a retry and the number of retries.
Disable – No retry of an unsuccessful call.
Dial-Out Delay Time (min)
Possible Settings: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10
Default Setting: 5
This delay applies to both the number of minutes before a new call is initiated for a
different alarm and the number of minutes between call retries. Refer to the previous
option, Call Retry.
1 to 10 – Number of minutes before a call is initiated or retried.
Alternate Dial-Out Directory
Possible Settings: None, 1, 2, 3, 4, 5
Default Setting: None
Specifies which alternate dial-out directory to use, if any, when a call cannot be
completed (due to busy, no answer, etc.). This refers to calls initiated for an ASCII alarm
or SNMP trap.
Both Alarm & Trap Dial-Out and Call Retry options must be enabled.
1, 2, 3, 4, or 5 – After attempting to reach the Primary Directory phone number five
times, this alternate dial-out directory phone number will be dialed up to five times.
NOTE: Refer to the Call Setup
None – No alternate phone number is used.
June 1997
Configuration Option Tables
section of Chapter 3.
A-21