Input Signal Table Objects - Paradyne 7110 User Manual

Zhone 7110 network-accessory: user guide
Hide thumbs Also See for 7110:
Table of Contents

Advertisement

MIB Descriptions

Input Signal Table Objects

C-28
Table C-13. Synchronous Port Table Objects (2 of 2)
Object, OID, Access
rs232SyncPortMode
(rs232SyncPortEntry 12 )
1.3.6.1.2.1.10.33.4.1.12
read-write
rs232SyncPortMinFlags
(rs232SyncPortEntry 14 )
1.3.6.1.2.1.10.33.4.1.14
read-write
The following is not supported:
rs232SyncPortIdle Pattern (rs232SyncPortEntry 13)
The Input Signal Table Objects contains entries for the input signals that can be
detected by the unit for the synchronous user data port. Clarification for objects
contained in this table as it applies to the unit is provided below.
Table C-14. Input Signal Table Objects
Object, OID, Access
rs232InSigName
(rs232InSigEntry 2 )
1.3.6.1.2.1.10.33.5.1.2
read-only
rs232InSigState
(rs232InSigEntry 3 )
1.3.6.1.2.1.10.33.5.1.3
read-only
rs232InSigChanges
(rs232InSigEntry 4 )
1.3.6.1.2.1.10.33.5.1.4
read-only
June 1997
Description
Specifies the port's mode of
data transfer.
Specifies the minimum
number of flag patterns the
port needs in order to
recognize the end of one
from and the start of
another.
Description
Contains the identification
of a hardware input signal.
Contains the current signal
state.
Indicates the number of
times that a signal has
changed from on to off, or
off to on.
Setting/Contents
Supports only the following
value:
fdx(1) – Full-duplex
The only valid value is 2.
Setting/Contents
Supports only the following
values:
rts(1) – Request To Send
dtr(4) – Data Terminal Ready
Supports only the following
values:
on(2) – The signal is asserted.
off(3) – The signal is
deasserted.
The object is incremented
each time that the signal is
sampled (every 100 ms) and
the signal state is different
from the previous state.
7110-A2-GB20-00

Advertisement

Table of Contents
loading

Table of Contents