Hardware options installation
This chapter provides detailed instructions on how to install hardware options.
For more information on supported options, see the product QuickSpecs on the HPE ProLiant 110 Gen10
Server website at:
http://www.hpe.com/servers/ml110-gen10
To view the warranty for your server and supported options, see Warranty information on page 133.
Introduction
Install any hardware options before initializing the server. For options installation information, see the option
documentation. For server-specific information, use the procedures in this section.
If multiple options are being installed, read the installation instructions for all the hardware options to identify
similar steps and streamline the installation process.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal
system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before beginning
any installation procedure. Improper grounding can cause electrostatic discharge.
Drive options
Drive installation guidelines
Depending on the configuration, the server supports SAS and SATA drives.
Observe the following general guidelines:
•
The system automatically sets all drive numbers.
•
If only one drive is used, install it in the bay with the lowest drive number.
For drive numbering, see Drive bay numbering on page 19.
•
Drives with the same capacity provide the greatest storage space efficiency when grouped into the same
drive array.
Drive support information
Depending on the drive cage installed, the server supports the following drive types:
•
Non-hot-plug LFF SATA drives
•
Hot-plug LFF SATA or SAS drives
•
Hot-plug SFF SATA or SAS drives
The server supports up to 16 drives in SFF configuration and 8 drives in LFF configuration.
The embedded HPE Smart Array S100i SR Gen10 Controller supports SATA drive installation. For SAS
support, install a type-p standup plug-in Smart Array controller option.
Hardware options installation
43