End Stop Behavior In Normal Operation; Approaching The End Stop Value; Figure 12 End Stop Behavior In Normal Operation When Approaching The End Stop Value - WAGO 750 Product Manual

Functions

4.2.8.1 End Stop Behavior in Normal Operation

4.2.8.1.1 Approaching the End Stop Value

No.
1
2
3
4
5
The end stop behavior is acknowledged by a positive SPL_EN edge.
22 Product manual | Version: 1.1.0
Proportional Valve Module 2-3-4
Figure 12: End Stop Behavior in Normal Operation When Approaching the End Stop Value
Event
Set SPL_EN to "1."
Change setpoint
Set DI to "1."
Change SPL_EN setting from
"0" to "1"
Set DI to "1."
Description/Behavior
Normal operation is activated.
Ramp starts.
Present current increases with parameterized ramp.
Rising ramp stops.
Actual value falls until the end stop value is reached.
Substitute value behavior is acknowledged.
Parameterized setpoint is approached again.
The positive edge of DI again causes the rising ramp to stop.
The actual value falls until the end stop value is reached without
DI being permanently actuated.
750-1632/000-100