Application Control Bytes V1_Ctrl And V2_Ctrl; Table 33 Application Control Bytes V1_Ctrl And V2_Ctrl - WAGO 750 Product Manual

Table of Contents

Advertisement

Functions

4.6.3 Application Control Bytes V1_CTRL and V2_CTRL

Bit 7
JOG_POS
Legend
JOG_POS
JOG_NEG
DITHER
RSEL
TEACH_EN
SPL_EN
56
Product manual | Version: 1.1.0
Proportional Valve Module 2-3-4
Bit 6
Bit 5
JOG_NEG
DITHER
This bit has two alternative functions depending on bit SPL_EN:
JOG_POS: jogging in positive direction
The function is active if SPL_EN = 0.
0: Hold present current.
1: Increase current.
TIP_POS: TIP mode is a time-limited variant of JOG mode:
From 0 to 1: Increase current, limited over a parameterized time pe-
riod.
This bit has two alternative functions depending on bit SPL_EN:
JOG_NEG: jogging in negative direction
The function is active if SPL_EN = 0.
0: Hold present current.
1: Reduce current.
TIP_NEG: TIP mode is a time-limited variant of JOG mode:
From 0 to 1: Current is reduced, limited over a parameterized time
period.
0: dither off
1: dither on
From 0 to 1: Dithering is switched on.
From 1 to 0: Dithering is switched off.
RampSelect: Specification for the positive and negative ramp.
The bits select the values from a parameter table (see
Tables 156 and 157
0: Value for present ramps is taken from SC_RISE/FALL1 parame-
ter.
1: Value for present ramps is taken from SC_RISE/FALL2 parame-
ter.
2: Value for present ramps is taken from SC_RISE/FALL3 parame-
ter.
3: Value for present ramps is taken from SC_RISE/FALL4 parame-
ter.
Triggering the teach-in function of the current controller:
0: Deactivate teach-in function.
1: Activate teach-in function.
Switching between JOG mode and normal operation:
0: JOG mode is active. When switching between them, the last cur-
rent that was output is retained.
1: JOG mode is not active. Normal operation is active. The setpoint
for the current (Vx_SETPOINT) is specified by the PLC.
Table 33: Application Control Bytes V1_CTRL and V2_CTRL
Bit 4
Bit 3
Bit 2
RSEL
TEACH_EN
[} 37]):
750-1632/000-100
Bit 1
Bit 0
SPL_EN
PWR_EN
8 Parameter

Advertisement

Table of Contents
loading

This manual is also suitable for:

753

Table of Contents