Safety Measures While Tractor "Belarus-2022.6" Operation With The Loader Installed - Belarus 2022.6 Operator's Manual

Table of Contents

Advertisement

To exclude contact and/or tractor and loader damage, minimum distances between
the tractor fixed elements and the loader coupled elements shall make not less than 0.1 m,
and in case of moving members – not less than 0.15 m.
A loader shall have the label "Maximum speed limitation" and also necessary warn-
ing labels, for example "Fix". Limiting values of load-carrying capacity shall be specified on
the fore of the loader operating equipment.
ATTENTION: INSTALLATION OF MOUNTED FRONT LOADERS OF VARIOUS
MANUFACTURERS IS ALLOWED ON TRACTOR "BELARUS-2022.6" IF IT IS PRO-
VIDED IN TECHNICAL DOCUMENTATION FOR THESE LOADERS!
ATTENTION: FRONT LOADERS WHICH ARE NOT DESIGNED FOR BEING
USED TOGETHER WITH TRACTOR "BELARUS-2022.6" SHALL NOT BE INSTALLED
ON THE TRACTOR!
Depending on the type of replaceable operating equipment installed, two modes of
loader operation are possible – "Loader" and "Bulldozer".
ATTENTION: THE LOADER MANUFACTURER SHALL PROVIDE A CONSUMER
WITH ALL KINDS OF NECESSARY TECHNICAL DOCUMENTATION INCLUDING CON-
FIRMATION OF POSSIBILITY OF LOADER COUPLING WITH TRACTOR "BELARUS-
2022.6"!

4.13.2 Safety measures while tractor "BELARUS-2022.6" operation with the loader installed

While operation with the loader installed, it is necessary to check tightening of fas-
teners of the loader mounting frame and tractor wheels, and tire pressure on shift-time ba-
sis.
While operation with the loader installed, it is required to observe safety require-
ments listed in subsection 3.3 "Safety measures while tractor operation".
Additionally during loader operation it is forbidden to:
- uplift load with weights exceeding those specified in the loader OM;
- fill the loader bucket amain, and to work on soft soils;
- place the bucket outside the slope crest when throwing off soil aslope (in order to
avoid tractor slipping);
- transport load in the bucket with the maximum boom length;
- work with cracks on rims and with tires damaged up to the cord or perforation
damage;
- leave the tractor when the load is lifted (for operator);
- make all types of turns and reverse movements when operating parts are sunk in
the soil;
- operate when lights, signalling system, steering or brakes have failures;
- carry out operations at nighttime when electrical equipment is faulty and the work-
ing area does not have sufficient lighting;
- lift people with the loader;
- lift and move loads with the loader if there are people in the dangerous zone (the
danger line near the loader moving members and operating parts is within 5 m, unless
other exclusive requirements are specified in the works certificate or manufacturer's in-
struction);
- carry out tractor maintenance with the loader arm raised;
- make loading and unloading operations under electric power lines;
- carry the loader bucket over a car cabin.
ATTENTION: TO IMPROVE PITCH STABILITY AND REDUCE LOAD ON FRONT
AXLE, THE TRACTOR COUPLED WITH THE LOADER CAN BE EQUIPPED WITH
REAR MOUNTED BALLAST WEIGHTS!
LOADER OPERATION ON THE SLOPE WITH MORE THAN 8° IS FORBIDDEN!
140
2022.6-0000010 OM

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents