Table of Contents
Advertisement
Figure 2.19.2 – Diagram of HLL valve group outlets connection to outer consumers
The outlet for the connection of the hydraulic motor drain pipe is shown in figure 2.19.3.
а) for tractors with the integrated block
of "BOSCH" company
2.20 Switching unit and electric cutout fuses
2.20.1 General information
Electric cutout fuses are intended for the protection of electrical lines against over-
loads and short circuit.
WARNING: TO AVOID BURNING OF TRACTOR WIRING, NEVER USE FUSES
WITH CURRENT RATING HIGHER THAN THE RATINGS SPECIFIED IN THIS SEC-
TION. IF A FUSE OFTEN BURNS OUT, FIND OUT THE CAUSE AND ELIMINATE THE
FAILURE!
2.20.2 Switching unit and fuses for electrical equipment
Switching unit 3 (figure 2.20.1) is intended for current supply, its distribution among the
consumers of tractor electrical equipment and for the protection of electrical lines against cur-
rent overloads and short circuit.
а) for tractors with the Integrated block
of "BOSCH" company
FREE DRAIN
Figure 2.19.3 – Arrangement of free drain outlet
b) for tractors with the hydraulic unit RP70-1523.1
56
2022.6-0000010 OM
b) for tractors with the
hydraulic unit RP70-1523.1
Advertisement
Table of Contents
Troubleshooting
