Providing Access To The Components For Maintenance Services - Belarus 2022.6 Operator's Manual

5.2 Providing access to the components for maintenance services

Before starting maintenance service operations, it is required to open tractor hood 3
(figure 5.2.1). Hood 3 can be opened and fixed in two positions.
To open hood 3 and fix it in the first position, it is necessary to do the following:
- open lock 2 by pulling the handle of control cable 1;
- uplift hood 3;
- secure it in the open position by means of link 4 in bracket 5;
- make sure that hood 3 is securely fixed in the uplift position.
To open hood 3 and fix it in the second position, it is necessary to do the following:
- open lock 2 by pulling the handle of control cable 1;
- uplift hood 3;
- secure it in the open position by means of link 4 in bracket 5;
- disconnect lamp-wiring assembly from the engine harness;
- uplift hood 3 slightly to remove link 4 from bracket 5;
- mount link 4 onto its proper location;
- holding hood 3 by hand, pull detent 7 along the tractor longitudinal axle from the
cab;
- uplift hood 3 into the second position;
- secure it in the open position by means of link 8 in bracket 9.
To close the hood, it is necessary to do the following:
- uplift hood 3 slightly to remove link 4 or 8 from the corresponding bracket 5 or 9 depend-
ing on the position in which hood 3 is opened;
- secure link 4 or 8 onto its proper location;
- lower hood 3 into the lower position until a specific click is heard (lock 2 comes into ac-
tion).
To get better access to the main cylinder tanks of hydraulic drives for clutch and
brakes control mounted on the cab, it is required to open hatch 6.
a) first position
1 – handle of control cable; 2 – lock; 3 – hood; 4 – link; 5 – bracket; 6 – hatch;
7 – detent; 8 – link; 9 – bracket.
Figure 5.2.1 – Hood opening and closing
146
2022.6-0000010 OM
b) second position