Safety Measures By Tractor "Belarus-1822.3/1822 .3/2022.3/2022; Operation With Loader Installed - Belarus 1822.3 Operator's Manual

Loader design is to provide possibility of fixing working attachments in transport po-
sition.
To exclude contact and/or tractor and loader damages the minimum distances between
fixed members of tractor and loader components attached to it should be not less than 0.1 m,
and in case of moving member – not less than 0.15 m.
The loader should bear marks "Maximum speed limitation", and also necessary
warning labels, for example: to "Fix". On loader operating equipment limit values of load-
carrying capacity should be specified on the fore.
ATTENTION:
1822.3/1822 .3/2022.3/2022 .3" OF MOUNTED FRONT LOADERS OF VARIOUS
MANUFACTURERS IS ALLOWED IN CASE IT IS PROVIDED FOR IN LOADERS TECH-
NICAL DOCUMENTATION!
ATTENTION: FRONT LOADERS WHICH ARE NOT DESIGNED FOR USE TO-
GETHER WITH TRACTOR "BELARUS-1822.3/1822 .3/2022.3/2022 .3" MUST NOT BE
INSTALLED ON THE TRACTOR!
Depending on replaceable operating equipment installed two modes of loader op-
eration – "Loader" and "Bulldozer" are possible.
ATTENTION: PROVIDING CONSUMER WITH ALL KINDS OF NECESSARY
TECHNICAL DOCUMENTATION, INCLUDING CONFIRMATION OF POSSIBILITY OF
COUPLING OF LOADER WITH TRACTOR "BELARUS-1822.3/1822 .3/2022.3/2022 .3",
COMES WITHIN DUTIES OF THE MANUFACTURER OF THE LOADER!

5.15.2 Safety measures by tractor "BELARUS-1822.3/1822 .3/2022.3/2022 .3"

operation with loader installed

During loader operation it is necessary to check on shift-time basis tightening of fasteners
of mounting frame of loader and wheeled tractor, and pressure in tires.
During loader operation observe safety requirements listed in subsection 4.3 "Safety
measures to be taken when operating the tractor".
Additionally during loader operation it is forbidden to:
- carry load with weights exceeding those specified in loader OM;
- fill loader bucket amain, to work on soft soils;
- place bucket outside slope crest when throwing off soil aslope (in order to avoid
tractor slipping);
- transport load in bucket at maximum boom length;
- work with cracks on rims and with tires damaged up to the cord or perforation
damage;
- to leave a tractor with lifted load;
- to make all types of turns and reverse movements with working attachments bur-
ied;
- work with faulty light, signalling system, steering and brakes;
- carry out operations at night with faulty electrical equipment and insufficient light of
a working area,
- lift people by means of loader;
- lift and move loads if there are people in dangerous zone (danger line is near the
moving members and working attachments of loader
requirements are specified in specification or manufacturer's instruction);
- carry out tractor maintenance with loader arm raised;
- make loading and unloading operations under electric power lines;
- carry loader bucket over a car cabin.
INSTALLATION
231
https://tractormanualz.com/
ON THE TRACTOR
is
within 5 m unless other exclusive
2022.3-0000010 OM
"BELARUS-