Table of Contents
Advertisement
2.10.2 Steering wheel adjustments
The steering wheel has the following adjustments:
- according to the horizon tilt angle;
- according to the height, along the steering shaft axis.
To change height positioning of the steering wheel, do the following:
- unscrew chuck 2 (figure 2.10.1) by 3-5 revolutions;
- set wheel 1 to a position comfortable for work;
- screw in chuck 2 with max. possible force of hand fingers.
The range of the steering wheel height adjustment is 100 mm, stepless.
To change the steering column tilt angle, do the following:
- pull handle 3.
- tilt the steering column to reach the position comfortable for work and releasing
handle 3, swing the steering column smoothly in longitudinal direction until fixed firmly.
The steering column can be tilted and fixed in four positions from 25° to 40° with 5°
interval.
1 – steering wheel; 2 – chuck; 3 – handle to fix the tilt of the steering column.
.
ATTENTION: WHEN FIXING THE STEERING COLUMN IN THE EXTREME FRONT PO-
SITION, SET THE GEAR SWITCH LEVERS OF GEARS AND RANGES INTO A NEU-
TRAL POSITION, START THE ENGINE AND WITH THE TRACTOR NOT MOVING
MAKE SURE THE STEERING CONTROL OPERATES WELL!
2.11 Parking brake control
Upper position of the lever 22 (figure 2.1.1) – parking brake "On";
Lower position of the lever 22 – parking brake "Off".
2.12 Handle for fuel supply manual control
When moving handle 36 (figure 2.1.1) into the extreme front position, max. fuel
supply is provided, when moving the handle into the extreme rear position – min. fuel
supply is provided which corresponds to the minimum idle speed.
2.13 Tractor pedals
2.13.1 Pressing pedal 24 (figure 2.1.1) disengages the clutch.
2.13.2 Pressing pedal 26 (figure 2.1.1) brakes the rear left wheel.
2.13.3 Pressing pedal 27 (figure 2.1.1) brakes the rear right wheel. A joint plate of
the brake pedals is intended for simultaneous braking with the right and left brakes.
2.13.4 Pressing pedal 28 (figure 2.1.1) increases the engine speed.
Figure 2.10.1 – Steering wheel adjustment
43
2022.6-0000010 OM
Advertisement
Table of Contents
Troubleshooting
