Belarus 2022.6 Operator's Manual page 126

The diagram for mounting a kit of ballast weight assembled with a bracket is shown in
figure 4.6.3. Information on how to mount ballast weights onto FLL is given in table 4.6.1.
1 – upper link; 2 – upper link tube handle; 3 – bracket with weights; 4 – lower links.
Figure 4.6.3 – Diagram for mounting ballast weights onto FLL
Table 4.6.1 – Information on how to mount ballast weights onto FLL
1 Name of equipment
2 Main function
3 Design features
4 LL type (as per GOST 10677)
5 Category (as per ISO 730-1)
6 Diameter of hinge joint sphere to couple with
lower links grippers, mm
7 Diameter of bracket opening to couple with upper
link, mm
8 Bracket mass with weights, kg
9 Bracket mass without weights, kg
__________________________________________________________________________
1)
Regarding mounted bracket coupling dimensions.
Mounting of a ballast weights kit assembled with a mounted bracket onto FLL shall be
carried out in the following way:
- approach the kit of ballast weights slowly with maximally lowered grippers of lower
links until the grippers jaw of lower links 4 (figure 4.6.3) is located under the hinge joints on
bracket 3 axis;
- to perform coupling, it is required to uplift front ends of lower links 4 until the hinge
joints are fixed in lower links grippers;
- connect upper link 1 by means of pin 4 (figure 4.3.11) to the bracket opening with
weights 3 (figure 4.6.3), simultaneously screwing or unscrewing out of tube 2 (figure 4.3.11)
screwed parts with hinge joints, after undoing counter nuts 1 and 3;
- further adjustment of weights operating position shall be carried out with a coupled
bracket by means of changing the length of upper link 1 (figure 4.6.3) by turning handle 2 of
upper link tube. After adjustment, screw in counter nuts 1 and 3 (figure 4.3.11).
1)
1)
126
2022.6-0000010 OM
Kit of mounted ballast weights assem-
bled with a bracket
Additional loading of front driving axle,
improvement of tractor weight distribution
by means of coupling to the tractor lift
linkage
It consists of a ballast weights kit with
a bracket
LL-2
Category 2
56
25,5
640
105