Belarus 2022.6 Operator's Manual page 102

Figure 4.3.2
Table 4.3.1 – Basic parameters and coupling dimensions of RLL
Standard size (configuration)
of the device
1 Category (acc. to ISO 730-1)
2 Design features
3 Assignment
4 Lower links
5 Lower links length, mm
6 Hinged joint width of the upper
(lower) link, mm
7 Diameter of a rear-end hinged
joint pin of the upper link, mm
8 Diameter of holes in rear hinge
joints of lower links, mm
9 Distance between PTO shaft end
extension butt end and suspension
axis, mm
1)
10 Column height
11 Length of the suspension axis
along the shoulders
12 Lifting capacity of the device,
3)
kN :
а) on the suspension axis;
b) at overhang of 610 mm from
the suspension axis
________________________________________________________________________
1)
Dimension refers to the implement coupled.
2)
The recommended type for basic use.
3)
It is not allowed to overload RLL higher than the tire load norm specified in table 3.2.2.
PTO shaft end extension
- Rear lift linkage diagramm of "LL-2" type
It consists of three links (one upper and two lower),
connected with the tractor with hinge joints, free
ends of links with hinge joints are connected to the
implement connecting elements while coupling
For connection (mounting) or coupling of mounted,
semi-mounted implements
Solid with on-board control system and changeable
hinge joints
, mm
1)
, mm
2)
LL-3
(figure 4.3.1)
Category 3
1060
51 (45)
32
37
595
685
965
65
45
102
2022.6-0000010 OM
PTO
area
LL-2
(figure 4.3.2)
Category 2
1060
51 (45)
25
28,7
608
610
825
65
45