Belarus 2022.6 Operator's Manual page 38

Table of Contents

Advertisement

Table 2.8.4 – The list of programmed parameter values for tractor "BELARUS-
2022.6"
________________________________________________________________________________________
1)
"910" is the value for tires 580/70R42. When mounting another type of tires, it is
required to set the parameter value "R" which corresponds to the rolling radius of the
mounted tires.
2)
On tractors "BELARUS-2022.6» readout of RPTO revolutions is carried out with
the help of PTO speed sensor. Considering this, any value, except for number "000", can
be set in parameter "KV2".
3)
On tractors "BELARUS-2022.6» only the value of the side fuel tank volume (175
litres) shall be set, so the data about the operation time on the remaining fuel and etc. are
formed without considering the fuel volume in the tank (the volume of the fuel tank under
the cab is 130 litres).
During operation, it is allowed to modify the parameter value of wheel rolling radius
"R", which is determined based on the tires installed on the tractor by measuring the dis-
tance from the wheel center to the mounting surface.
IT IS FORBIDDEN TO MODIFY THE ENTERED VALUES OF ALL OTHER PA-
RAMETERS (FACTORY DEFAULTS)!
"Z" parameter
Z is the number of teeth of final gears of the rear wheels (right and
left), over which the travel speed (rotation speed) sensors are in-
stalled.
"I" parameter
I is the gear ratio multiplier of the wheel-hub drive
"R" parameter
R is the rear axle rolling radius, mm. When reprogramming, this
parameter can be modified with a 5 mm step
"KV2" parameter
KV2 is the PTO gear ratio
"ZV" parameter
ZV is the number of teeth of the RPTO reduction unit toothed
washer
"V" parameter
V is the fuel tank volume, l
Also, when the "Parameter" button is pressed in the program-
ming mode, the list of programmed parameters contains an inde-
pendent "T" parameter of precise readout of the astronomic ser-
vice hours of the engine. This parameter cannot be modified, it is
the precise number (to 0,01 of hour) of engine service hours.
2)
3)
38
2022.6-0000010 OM
1)
.

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents