Safety Measures While Tractor "Belarus-922.6" Operation With The Loader Installed - Belarus 922.6 Operator's Manual

To exclude contact and/or tractor and loader damages, minimum distances between
the tractor fixed elements and the loader coupled elements shall make not less than 0.1 m,
and in case of moving members – not less than 0.15 m.
A loader shall have the label "Maximum speed limitation" and also necessary warning
labels, for example "Fix". Limiting values of load-carrying capacity shall be specified on the
fore of the loader operating equipment.
ATTENTION: INSTALLATION OF MOUNTED FRONT LOADERS OF VARIOUS
MANUFACTURERS IS ALLOWED ON TRACTOR "BELARUS-922.6" IF IT IS PROVIDED
IN TECHNICAL DOCUMENTATION FOR THESE LOADERS!
ATTENTION: FRONT LOADERS WHICH ARE NOT DESIGNED FOR BEING USED
TOGETHER WITH TRACTOR "BELARUS-922.6" SHALL NOT BE INSTALLED ON THE
TRACTOR!
Depending on the type of replaceable operating equipment installed, two modes of
loader operation are possible – "Loader" and "Bulldozer".
ATTENTION: THE LOADER MANUFACTURER SHALL PROVIDE A CONSUMER
WITH ALL KINDS OF NECESSARY TECHNICAL DOCUMENTATION INCLUDING CON-
FIRMATION OF POSSIBILITY OF LOADER COUPLING WITH TRACTOR "BELARUS-
922.6"!
4.13.2 Safety measures while tractor "BELARUS-922.6" operation with the
loader installed
While operation with the loader installed, it is necessary to check tightening of fas-
teners of the loader mounting frame and tractor wheels, and tire pressure on shift-time ba-
sis.
While operation with the loader installed, it is required to observe safety requirements
listed in subsection 3.3 "Safety measures while tractor operation".
Additionally during loader operation it is forbidden to:
- uplift load with weights exceeding those specified in the loader OM;
- fill the loader bucket amain, and to work on soft soils;
- place the bucket outside the slope crest when throwing off soil aslope (in order to
avoid tractor slipping);
- transport load in the bucket with the maximum boom length;
- work with cracks on rims and with tires damaged up to the cord or perforation dam-
age;
- leave the tractor when the load is lifted (for operator);
- make all types of turns and reverse movements when operating parts are sunk in
the soil;
- operate when lights, signalling system, steering or brakes have failures;
- carry out operations at nighttime when electrical equipment is faulty and the working
area does not have sufficient lighting;
- lift people with the loader;
- lift and move loads with the loader if there are people in the dangerous zone (the
danger line near the loader moving members and operating parts is within 5 m, unless other
exclusive requirements are specified in the works certificate or manufacturer's instruction);
- carry out tractor maintenance with the loader arm raised;
- make loading and unloading operations under electric power lines;
- carry the loader bucket over a car cabin.
ATTENTION: TO IMPROVE PITCH STABILITY AND REDUCE LOAD ON FRONT
AXLE, THE TRACTOR COUPLED WITH THE LOADER CAN BE EQUIPPED WITH REAR
MOUNTED BALLAST WEIGHTS!
124
922.6-0000010 OM