Belarus 2022.6 Operator's Manual page 131

ATTENTION: TRACTOR MANUFACTURER SHALL NOT BE RESPONSIBLE FOR
THE COUPLED IMPLEMENTS CARDAN SHAFTS FAILURES. CARDAN SHAFTS SPEC-
IFICATIONS AND DESIGN ARE IN SPHERE OF RESPONSIBILITY OF THE IMPLE-
MENTS AND CARDAN SHAFT MANUFACTURERS!
ATTENTION: THE COUPLED IMPLEMENT CARDAN SHAFT SHALL PROVIDE
RATED-LOAD TORQUE TRANSFER WHEN ROTATION FREQUENCY IS AT LEAST
540 RPM OR 1000 RPM, DEPENDING ON THE MODE SET!
ATTENTION: DO NOT USE CARDAN SHAFTS WITHOUT APPROPRIATE PRO-
TECTIVE DEVICES AND IF THEY ARE SELF-MANUFACTURED OR DAMAGED!
ATTENTION: BE CAREFUL WHILE COUPLING OF THE IMPLEMENTS WITH
THE CARDAN DRIVE - CARDAN SHAFT ANGLES ARE LIMITED BY THE TRACTOR
STRUCTURAL ELEMENTS, FOR EXAMPLE BY THE LIFTING DEVICE GUIDING RODS
OR TRACTOR WHEELS. DUE TO MUTUAL TOUCH-DOWN OF THE CARDAN SHAFT
AND OTHER STRUCTURAL ELEMENTS, SOME BREAKAGE OF THE IMPLEMENT
TRAILER CAN HAPPEN OR, FOR EXAMPLE TRACTOR TIRES OR CARDAN SHAFT
DAMAGE!
ATTENTION: WHEN THE IMPLEMENT IS OPERATED WITH THE CARDAN
DRIVE, THERE IS HAZARD OF PROCESS MATERIAL OR THE IMPLEMENT PARTS
RELEASE. FOR THIS REASON IT IS NECESSARY TO OBSERVE SAFE DISTANCE!
ATTENTION: THE WIDTH OF THE RPTO PROTECTIVE DEVICE CLEARANCE
MAKES UP LESS THAN 360MM. FOR THIS REASON, WHILE CONNECTING THE
CARDAN SHAFT TO THE RPTO SHAFT END EXTENSION OF TYPE 3 (PTO 3), IT IS
REQUIRED TO BE CAREFUL IN ORDER TO EXCLUDE ANY HAND INJURIES! NO
SPECIAL INSTRUMENTS OR DEVICES FOR CONNECTING THE CARDAN SHAFT TO
THE SHAFT END EXTENSION OF TYPE 3 ARE REQUIRED!
IT IS FORBIDDEN TO USE POWER TAKE-OFF SHAFTS WITHOUT CORRE-
SPONDING SAFETY GUARDS!
While the implement cardan shaft connection to the PTO shaft end extension, the
following rules and requirements shall be observed:
1. Check the engaged PTO shaft speed mode for compliance according to the trac-
tor PTO shaft end extension type and the implement PRS installed, check the engaged
rear PTO drive (independent/synchronous) for compliance.
2. Before activation, detach the cardan shaft into two parts.
3. Visually Inspect the cardan shaft, PTO shaft and PRS for absence of mechanical
damage and for completeness of the set. Clear the PTO shaft end extensions from dirt if
needed, and lubricate them according to the lubrication chart given in the implement op-
eration manual.
4. The part of cardan shaft which has the icon "Tractor" on it, shall be coupled to the
PTO shaft end extension, and the second part – to the implement PRS accordingly. Re-
member to fasten the connecting splined bushings on the PTO and PRS shaft ends prop-
erly: a fastening method shall be specified by the cardan shaft manufacturer.
5. The implement cardan shaft end yokes from the side of PTO shaft and PRS shall
be in the same plane as shown in figure 4.9.1.
Figure 4.9.1 – Cardan shaft mounting diagram
131
2022.6-0000010 OM