Fuses For Electronic Systems Of Rear Axle Dl, Fda, Gb Reduction Unit, Fpto And Rll Control - Belarus 2022.6 Operator's Manual

There are two spare accessory fuses 2 (figure 2.20.12) with rated value 60 A and
80 A in covers of fuse blocks 5 (figure 2.20.7 and figure 2.20.9). To get an access to spare
accessory fuses 2, it is required to remove blind plug 3 out of fuse block cover 1.
Figure 2.20.12 – Arrangement of spare accessory fuses in the fuse block
2.20.3 Fuses for electronic systems of rear axle DL, FDA, GB reduction unit,
FPTO and RLL control
To access the cutout fuses of electronic control systems (ECS), turn off screw 3
(figure 2.20.13) on cap 2 of side console 1 and open the cap.
Figure 2.20.13 – Location of fuses for ECS of rear axle DL, FDA, GB reduction unit,
The fuses for ECS of rear axle DL, FDA, GB reduction unit, FPTO (if mounted) and
RLL are shown in figure 2.20.14.
Cable colors: K – red, O – orange, P – pink, Ч – black, Ж – yellow, С - grey
Figure 2.20.14 – Fuses for ECS of rear axle DL, FDA, GB reduction unit, FPTO and RLL
Five cutout fuses (figure 2.20.14) protect the following electric circuits from over-
charge:
1 – FDA drive control (7,5 А);
2 – rear axle DL control (7,5 А);
3 – FPTO control, if mounted (7,5 А);
4 – RLL control (7,5 А);
5 – GB reduction unit control (15 А);
6 – duplicate (7,5 А).
1 – cover; 2 – spare accessory fuse; 3 – blind plug.
1 – side console; 2 – cap; 3 –screw.
FPTO and RLL.
GB reduction unit
Power supply "+12V" after turning
the starter and instruments switch
key to the position "Instruments
power supply"
FPTO
63
2022.6-0000010 OM
Connector between fuses
DL
FDA
Power supply "+12V"
after engine start
Cable of control systems, DL,
FDA and GB reduction unit
Cable of RLL control
system