Belarus 2022.6 Operator's Manual page 22

The layout of key positions of the starter and instruments disconnect switch is given
in figure 2.2.2 and on the informational plate of the switch.
Figure 2.2.2 – Layout of key positions of the starter and instruments disconnect switch
ATTENTION: THE REPEATED STARTER ENGAGEMENT IS POSSIBLE ONLY
AFTER RETURN OF THE KEY INTO THE POSITION "0" OF THE SWITCH. TO TURN
THE STARTER AND INSTRUMENTS SWITCH INTO THE POSITION "III" IT IS NECES-
SARY TO PRESS IN THE KEY WHEN IN "0" POSITION AND TURN IT CONTRA-
CLOCKWISE!
The multifunctional under-wheel switch 2 on the left (fig 2.2.1) provides activation of
turn blinkers, switching between upper and lower beam of headlights, upper beam signal-
ling (blinking), audible beep.
Turn blinkers are activated when shifting under-wheel switch 2 lever from the inter-
mediate position forward ("a" – right turn) or backwards ("b" – left turn) according to figure
2.2.3. After tractor turning, the lever automatically returns to the initial position.
To switch on road headlights, set central light switch 5 (fig. 2.2.1) into the position
"III" as it is shown below, and set the under-wheel switch lever into the intermediate posi-
tion "c" – "lower beam" according to figure 2.2.3. For switching on "upper beam", push the
switch lever against the stop (position "d"). The positions of a lever "lower/upper beam"
shall be fixed.
When pulling the lever against the stop (position "e", fig.2.2.3) from the position
"lower beam", non-fixed engagement of upper beam is carried out, upper beam blinking,
irrespective of the central light switch position.
The audible beep is activated when pressing the lever in axial direction (the switch
lever axle). The beep can be activated in any position of the switch lever.
Figure 2.2.3 – The operation scheme of the multifunctional under-wheel switch on the left
Multifunctional under-wheel switch on the right 3 (figure 2.2.1) provides the en-
gagement of two-speed windscreen wiper and washer.
b
22
2022.6-0000010 OM