Remote Buttons Of Rll Control System - Belarus 2022.6 Operator's Manual

ATTENTION: THE "DAMPENING" MODE IS ACTIVE ONLY WHEN HANDLE 11 IS
IN THE "UPLIFT" POSITION!
ATTENTION: DURING FIELD WORK (TILLAGE, CULTIVATION, ETC.) THE
"DAMPENING" MODE SHALL BE TURNED OFF!
Your tractor can be equipped with the RLL control panel PU-03 manufactured by
"Izmeritel" plant and shown in figure 2.17.2.
1 – handle of lift linkage control (position 16 – uplift; position 15 – off; position 14 – lower-
ing (in operation – automatic control); position 3 – mode of implement deepening in case it
raises (non-fixed)); 2 –retainer to lock the lift linkage control handle; 4 – annunciator of
linkage uplifting (red color); 5 – handle to adjust depth of soil tillage; 6 – troubleshooting
annunciator (red color); 7 – handle to adjust height limit of linkage uplifting; 8 – "dampen-
ing" button; 9 – "dampening" annunciator (green color); 10 – handle to adjust speed of
lowering; 11 – RLL position indicator (green color, upper scale point – RLL in max. raised
position, lower scale point – RLL fully lowered); 12 – handle to select control method; 13 –
annunciator of linkage lowering (green color).
Figure 2.17.2 – Rear lift linkage control panel PU-03
Note – RLL position indicator 11 (figure 2.17.2) is not used on "BELARUS-2022.6"
tractors.
The rules on using the RLL control panel PU-03 manufactured by "Izmeritel" plant
are similar to the rules on using the RLL control panel produced by "BOSCH" company,
shown in figure 2.17.1.

2.17.3 Remote buttons of RLL control system

Remote buttons of RLL control are used as a rule for coupling agricultural imple-
ments and machines to the rear lift linkage.
Uplift and lowering of the rear lift linkage with remote buttons on rear wheel fenders
can be carried out at different control modes – handles 4, 6, 7, 8, 11 (figure 2.17.1) and
similar handles of the RLL control console PU-03 can be left in any position, as the system
of control from inside the cab is blocked in this case.
To lift the RLL, press any of buttons 4 (figure 2.17.3) and hold it pressed. To lower
the RLL, press any of buttons 5 and hold it pressed.
For safety reasons control with remote buttons shall be performed with interruption
of work. Pressing uplift button 4 (lowering button 5) and holding it pressed lifts up (lowers)
the RLL for 5 sec., then it stops. For further uplifting (lowering) it is necessary to press the
corresponding button once again and hold it pressed!
Then after attaching the implement, activation and operation with RLL shall be per-
formed in accordance with subsection 2.17.2.
52
2022.6-0000010 OM