Rear Wheel Track Formation - Belarus 2022.6 Operator's Manual

3.2.9 Rear wheel track formation

Tractor rear wheels are mounted on hub groups which consist of split conic bush-
ings 3 and 4 (figure 3.2.4) and hub group housing 2.
The bushings are tightened into the hub group housing with eight bolts 1 (M20) with
a torque from 550 to 600 Nm, clenching the semiaxle.
1 – tie bolts; 2 – hub group housing; 3 – upper bushing; 4 – lower bushing;
The rear wheel track with the wheels of basic configuration 580/70R42 is changed
by moving the hub and the wheel along the semiaxle and by replacing the wheels from
one sideboard to the other one.
To change the rear wheel track, do the following:
- put the tractor on a flat ground, put the stops under the front and rear wheels,
clean the semiaxles from dirt;
- jack up the corresponding semiaxle tube;
- turn off the wheel retaining nuts and remove the wheel;
- release four tie bolts 1 (figure 3.2.4) of bushings 3 and 4 (two at each bushing) for
three complete turns. Screw out the rest of the tie bolts. Remove the blind plugs from the
dismounting holes. Screw in the bolts which were screwed out from the bushings into the
dismounting threaded holes;
- in case it is impossible to squeeze out the bushings with the help of tie bolts 1, fill
kerosine or other penetrant into the split between the bushings and the hub group housing,
wait for some time and then screw in the dismounting bolts, tapping on the hub group
housing at the same time until the bushings are completely squeezed out;
- shift the hub group onto the required track (use table 3.2.3 to set track "K" (figure
3.2.5) by measuring dimension «L» from the semiaxle butt end to the bushing butt end);
- screw out the tie bolts from the dismounting holes and screw them into the bush-
ings. Screw in the tie bolts with a torque from 550 to 600 Nm in stages – until all the bolts
are screwed in with the required torque;
- mount the wheel onto the hub group, tighten the wheel retaining nuts with a torque
from 700 to 750Nm, set the blind plugs to their places;
- set the other wheel track in the same way;
- check and tighten the tie bolts and wheel retaining nuts after the first operation
hour, after the first eight – ten operation hours and every succeeding 125 operation hours.
5 – dismounting holes.
Figure 3.2.4 – Rear wheel hub group
86
2022.6-0000010 OM