Belarus 2022.6 Operator's Manual page 156

To clean the condenser from the fan side, it is required to do the following:
- unscrew four bolts (figure 5.4.11);
- carefully uplift condenser 2 with mounted onto it brackets 3 and 4 and filter-drier,
preventing fitting pieces 6 from turning;
- carry out fitting pieces 6 cleaning, as specified above;
- if necessary, carry out cleaning of CAC radiator, according to clause 5.4.1.16;
- mount the conditioner condenser back on its place.
1 – bolt; 2 – condenser; 3, 4 – brackets; 5 – filter-drier; 6 – fitting piece.
CORROSIVE DETERGENT COMPOSITIONS SHALL NOT BE USED!
5.4.1.16 Operation 15. Check/cleaning of the engine water radiator and the engine
CAC-radiator
Check cleanliness of the hood mask, engine CAC-radiator core and engine water radia-
tor. In case it is clogged, do the following actions:
- carry out cleaning of the hood mask with compressed air at both sides;
- carry out CAC-radiator cleaning with compressed air. Direct the air flow perpendicular
to the CAC-radiator plane from top downward. In case of severe CAC-radiator clogging, rinse it
with hot water under pressure of not more than 0.2 MPa and blow it off by compressed air;
- carry out water radiator cleaning with compressed air. Direct the air flow perpendicular
to the water radiator plane from top downward. In case of severe water radiator clogging, rinse
it with hot water under pressure of not more than 0.2 MPa and blow it off by compressed air;
- radiator cores shall be cleaned both from the hood mask side and from the engine fan
side.
ALKALINE SOLUTIONS AND CORROSIVE DETERGENT COMPOSITIONS SHALL NOT BE
USED!
5.4.1.17 Operation 16. Check /rinse of RLL gripper tools
Note – The operation shall be carried out while mounting of lower links with gripper
tools on the tractor RLL.
It is required to check the cavity where the hinge joint locking mechanism in gripper
tools 1 (figure 5.4.12) of the RLL is located. In case of dirt accumulation, clean internal cavities
in gripper tools and rinse them with water.
Figure 5.4.11 – Uplifting of conditioner condenser
1 – gripper tool; 2 – link.
Figure 5.4.12 – RLL gripper tool
156
2022.6-0000010 OM