Drawbar Hitch Dh-1М-01 (Draw Bar) - Belarus 2022.6 Operator's Manual

4.4.5 Drawbar hitch DH-1М-01 (draw bar)
Figure 4.4.4 – Installation variant diagram of DH-1М-01 (draw bar)
Table 4.4.4 – Basic parameters and coupling dimensions of DH -1М-01(draw bar)
Standard size (configuration)
1. Variant
2. Mounting location
3. Assignment
4. Design features
5. Distance between the PTO butt end and the
connecting pin axis, mm
6. Vertical load on DH in hitch point, kN, not more
than
7. Turning angle of the implement trailing device
in horizontal plane, degrees, not less than
8. Connecting pin diameter, mm
9. Protective device type
10. Connection point of the protective device on
the tractor
11. Relative calculated value of axial forces, kN,
not more than
___________________________________________________________________________________________________________
1)
Implement accessory.
ATTENTION: MOUNTING OF COVER PLATE ON THE DRAW BAR BOTTOM
(WITH OVERTURN) TO REDUCE HEIGHT OF YOKE POSITIONING IN RELATION TO
THE SUPPORTING SURFACE IS NOT ALLOWED!
DH -1М-01 (draw bar)
First position
At the bottom of the rear axis body
and rear lifting device
For connection and coupling of
trailed, semi-trailed implements with
traveling wheels, excluding tractor
trailers and semi-trailers
Draw bar with possibility to change its
horizontal position in relation to the
RPTO butt end
400
15
Safety chain (rope)
Lifting device openings
114
2022.6-0000010 OM
Second position
500
11.5
±60
30
1)
70.1