Belarus 2022.6 Operator's Manual page 8

Introduction
The present manual is designed for studying the structure, operation rules and mainte-
nance of tractors "BELARUS-2022.6".
Scrutinize this manual. It will help you to study the rules of correct operation and main-
tenance.
Failure to follow these instructions can lead to operator's injury or a tractor breakdown.
Tractor operation, its maintenance and repair shall be carried out only by employees,
familiar with all of its parameters and characteristics and informed about necessary safety re-
quirements to prevent casualties.
Due to constant tractor development, some changes which are not specified in the pre-
sent manual can be introduced in the structure of certain units and parts.
Any arbitrary changes made by a consumer release the manufacturer from responsibil-
ity for possible further injuries to the operator and a tractor breakdown.
Adopted abbreviations and conventional notations:
ADL – automatic differential lock;
AB – accumulator battery;
DL – differential lock;
RADL – rear axle differential lock;
PLU – pilot lamps unit;
FB – fuse block;
FC – fast coupling;
PTO – power takeoff shaft;
PRS – power reception shaft;
HSC – hydrostatic steering control;
HLL – hydraulic lift linkage;
HS – hydraulic system;
FFVS – frequency fuel volume sensor;
STM – shift-time maintenance;
RPTO – rear power take-off shaft;
SPTA – spare parts, tools and accessories;
RA – rear axle;
RLL – rear lift linkage;
II – integrated indicator;
GB – gearbox;
MI – multifunction indicator;
MTU – machine and tractor unit;
CC – coupling clutch;
LL – lift linkage;
CL – coolant;
IAC – inlet air cooler;
FDA – front driving axle;
FPTO – front power take-off shaft;
FLL – front lift linkage;
VC – voltage converter;
FDAD – front driving axle drive;
CM – control module;
IICP – integrated indicator control module;
HPH – high pressure hoses;
HP – heating plugs;
SM – seasonal maintenance;
MS – maintenance service;
MS1 – maintenance service No1;
MS2 – maintenance service No2;
MS3 – maintenance service No3;
DH – drawbar hitch;
ECS – electronic control system;
EECS – engine electronic control system;
EE – electrical equipment.
8
2022.6-0000010 OM