Drawbar Hitch Dh-Зv (Long Towing Yoke) - Belarus 2022.6 Operator's Manual

4.4.3 Drawbar hitch DH-ЗV (long towing yoke)
Figure 4.4.2 – Installation variant diagram of DH-ЗV (long towing yoke)
Table 4.4.2 – Basic parameters and coupling dimensions of DH-ЗV (long towing yoke)
Standard size (configuration)
1. Mounting location
2. Design features
3. Assignment
4. DH yoke dimensions, mm:
а) connecting pin diameter
b) yoke position
by rear PTO shaft
c) distance between the PTO butt end and
the connecting pin axis
5. Trailing device for coupling to DH:
а) type
b) vertical load in hitch point, kN, not more
than
c) turning angle of the implement trailing de-
vice in horizontal plane, degrees, not less
than
d) protective device type
e) connection point of the protective device
on the tractor
6. Relative calculated value of axial forces,
kN, not more than
__________________________________________________________________________________________________
1)
Recommended.
2)
Implement accessories.
ATTENTION: IT IS FORBIDDEN TO PUT DH-3V YOKE TO A POSITION WHERE
ITS BODY OVERHANGS THE DH SUPPORTING BRACKET END (UP AND DOWN)
FOR MORE THAN 15 ММ!
1)
for the implements driven
DH -3V (long towing yoke)
Rear lifting device
Rotational, height adjustable
For coupling of trailed implements, in-
cluding tractor trailer type equipped with
drawbar clevises
Lower position, as shown in figure 4.4.2
Rigid, with tractor drawbar clevis
Safety chain (rope)
Lifting device openings
112
2022.6-0000010 OM
40
400
20
±60
2)
70.1