Belarus 2022.6 Operator's Manual page 77

- after the heating plug pilot lamp goes out, start the engine, for which depress the
clutch pedal and turn the key of starter and instruments switch from "I" position ("instru-
ments on") into position "II" (engine start);
- hold the key of the starter switch turned until the engine is started, but not longer
than 20 seconds; if the engine fails to start, carry out a repeated start-up not earlier than
after one minute;
- after the engine is started, release the clutch pedal, check functioning of all signal
lamps and gauge indications (coolant temperature, oil pressure in the engine, on-board
circuit voltage, etc.). Let the engine run at low rpm until pressure stabilizes within gauge
operation range. Actually measured parameters and operation states of tractor systems
and units are displayed on the integrated indicator, on the dashboard, on the pilot lamp
unit, on the control panel of the rear axle DL, of FDA drive, on the engine control system
panel and on the information screen. The troubleshooting annunciator of RLL electronic
control system lights up on RLL control panel - it indicates the workability and blocking of
the RLL control system;
- after engine start, there is engaged the GB reduction unit pass at which the engine
was stopped. If the lowest pass of GB reduction unit is engaged –a light emitted diode of
green color lights up on the lever handle for switching GB reduction unit gears and passes,
and on the control panel for rear axle DL and FDA drive – annunciator for actuation of GB
reduction unit lowest pass, indicating that the lowest pass of GB reduction unit is engaged.
If the highest pass of GB reduction unit is engaged - a light emitted diode of red color lights
up on the lever handle for switching GB reduction unit gears and passes, and on the con-
trol panel for rear axle DL and FDA drive – annunciator for actuation of GB reduction unit
highest pass, indicating that the highest pass of GB reduction unit is engaged.
- a pilot lamp indicating the charge of additional AB with the voltage of 24V shall go
out after the engine start – it indicates that the additional AB with the voltage of 24V is be-
ing charged through the voltage converter. If the pilot lamp indicating the charge continues
to glow after the engine start – it indicates that the additional AB is not being charged and
it is required to eliminate the failure.
IT IS FORBIDDEN TO OPERATE THE TRACTOR IN CLOSED ROOMS WITHOUT
REQUIRED VENTILATION (AIR EXCHANGE). EXHAUST GASES MAY LEAD TO A LE-
THAL OUTCOME!
IT IS FORBIDDEN TO RUN THE ENGINE WITH THE SYSTEMS OF COOLING
AND ENGINE LUBRICATION UNFILLED!
ATTENTION: THE TRACTOR CAB IS EQUIPPED WITH A SINGLE-OCCUPANCY
SEAT AND THE OPERATOR IS THE ONLY PERSON TO STAY IN!
ATTENTION: START THE ENGINE AND INSPECT GAUGES ONLY WHEN STAY-
ING IN THE OPERATOR'S SEAT!
ATTENTION: REMEMBER THAT THE ENGINE START IS POSSIBLE ONLY
WHEN THE RANGE SHIFTING LEVER IS SET INTO A NEUTRAL POSITION!
ATTENTION: WHILE STARTING THE ENGINE, THERE MUST BE NO PEOPLE
UNDER, IN FRONT OF AND BEHIND THE TRACTOR, AS WELL AS BETWEEN THE
TRACTOR AND AN IMPLEMENT COUPLED TO IT!
IT IS FORBIDDEN TO START THE ENGINE TAKING THE TRACTOR IN TOW, AS
IT MAY RESULT IN ENGINE BREAKDOWN. START THE ENGINE ONLY WHEN YOU
STAY IN THE OPERATOR'S SEAT!
77
2022.6-0000010 OM