Belarus 2022.6 Operator's Manual page 92

Do not operate the tractor with gages out of order.
It is not allowed to inflate tires without pressure control.
While coupling the tractor with agricultural implements, additionally observe safety
measures concerning the use of these implements.
Before coupling the tractor with agricultural implements, make sure the automatic
grips of the lower and upper links of the RLL are clean and faultless. It is forbidden to op-
erate with the automatic grips out of order, with their inner cavities stuffed with dirt and for-
eign particles.
If the tractor front part rises from the ground when heavy implements are hinged on
the mechanism of the rear lift linkage, mount front ballast weights.
Do not work under raised agricultural implements. Do not leave implements uplifted
when stopping for a long time.
Before lifting and lowering a hinged agricultural implement and also when turning
the tractor, make sure there is no danger of catching somebody or stumbling on the hur-
dle.
The mounted and semi-mounted machine shall be lowered into its operating posi-
tion and uplifted into the transport position only with a straight-line movement of the as-
sembly unit.
To avoid breakdown of the tractor or the agricultural implement, drive and turn the
tractor assembly with the agricultural implement uplifted only after you make sure the rear
PTO is disengaged.
While linking and hinging the agricultural machines and implements on the tractor,
the rear operator shall stay at a safety distance until the operation is fully stopped. The
linkage (hinge) shall be started only after the tractor operator gives a command.
While linking the machine cardan shaft to the PTO, disengage the PTO, stop the
tractor with the parking brake and stop the engine.
After disconnecting the machines driven by the PTO, remove the cardan drive and
cover the PTO shaft end extension with the protective cap.
Cardan shafts, transferring torque from the tractor PTO to the implement working
units, shall be safeguarded.
While operating with stationary machines, driven by the PTO, always engage the
parking brake and lock rear wheels at the front and at the back. Make sure the machine is
securely fixed.
Make sure the safeguards of the PTO shaft end extensions are mounted and, if the
PTO is not used, put back the cap of the PTO shaft end extension.
Do not wear loose clothes when working with the PTO or near rotating equipment.
To avoid breakdown of the tractor or the agricultural machine, turning the tractor as-
sembly is possible only after the working units of the machine have been fully raised from
the ground.
When tractor assemblies are operating in a column, they shall have an interval not
less than 30 m between each other.
Depending on operation conditions, use natural ventilation of the cab or the unit of
air cooling and heating.
During tractor operation, the operator shall use standard means of protection for
hearing organs.
In case the tractor assembly is operated or is driven in an area of power transmis-
sion lines, a distance between the top of the tractor assembly and wires shall conform to
table 3.3.1.
Table 3.3.1
Line voltage, кV, up to
Horizontal distance, m, at least
Vertical distance, m, at least
11 20-25 110
1,5 2 4
1 2 3
92
2022.6-0000010 OM
154-220 330-500
6 9
4 6