Belarus 2022.6 Operator's Manual page 151

5.4.1.4 Operation 3. Check of oil level in the HLL tank
Before checking oil level, set the tractor on the flat horizontal ground. Lower RLL
links to the extreme lower position. Stop the engine and engage the parking brakes.
HLL tank is located on the clutch coupling housing.
Check the oil level visually according to oil level indicator 3 (figure 5.4.3) on the
tank. The level shall be between the marks "O" and "П" of the oil level indicator. If neces-
sary, refill the oil up to the "П" mark through an oil filler neck, for which turn off plug 1.
While operating the tractor coupled with implements requiring higher oil consump-
tion, fill the oil up to the mark "C" on the oil level indicator with the hydraulic cylinder re-
tracted rods of the implement and the tractor.
ATTENTION: OIL LEVEL CHECKING OPERATION IN THE HYDRAULIC LIFT
LINKAGE TANK SHALL BE CARRIED OUT ONLY WITH THE RETRACTED RODS OF
RLL HYDRAULIC CYLINDERS AS WELL AS OF THE IMPLEMENTS COUPLED WITH
THE TRACTOR!
WARNING: BE CAUTIOUS TO AVOID CONTACT WITH HOT OIL!
5.4.1.5 Operation 4. Check of oil level in the HSC tank
Before checking oil level in the HSC tank 3 (figure 5.4.4), it is required to set the
tractor on flat horizontal ground. Stop the engine and engage the parking brakes.
The HSC oil tank is located in front, on front weights bracket.
Check the oil level visually according to oil level indicator 1 on HSC tank 3. The level
shall be between the upper and lower marks of the oil level indicator. If necessary, remove
plug 2 of the oil level indicator and refill the oil up to the oil level indicator upper mark. Put
plug 2 back on its place.
1 – oil filler neck plug; 2 - HLL tank; 3 –oil level indicator.
Figure 5.4.3 – Check of oil level in the HLL tank
1 – oil level indicator; 2 – plug; 3 – HSC tank.
Figure 5.4.4 – Check of oil level in HSC tank
151
2022.6-0000010 OM