Belarus 2022.6 Operator's Manual page 100

To ensure the required position of the implement, the following RLL vertical and hor-
izontal adjustments by means of upper link, lifting rods and buckles are provided:
1. Adjustment of the upper link length.
It is carried out in order to ensure equal soil penetration of operating parts (running
depth levelling of operating parts located one after another in the direction of tractor
movement). If the mounted plough frame is bent forward in the direction of tractor move-
ment and the plough front body penetrates deeper than the rear, it is required to extend
the upper link; and if the plough front body penetrates with less depth than the rear, the
upper link shall be shortened.
2. Adjustment of left or right lifting rod length.
The adjustment is carried out in the following cases:
- to ensure the horizontal position of the implement;
- to ensure even depth of soil processing with the coupled machine operating parts
across the lifting rod width.
3. Adjustment of both lifting rods length, upper link length for the implement trans-
port position.
The adjustment is carried out in the following cases:
- to ensure the required road clearance;
- to ensure sufficient safe distance between the tractor elements and the implement,
excluding contact of implement parts with the tractor (the clearance shall be at least 100
mm).
4. Adjustment of both buckles length.
The adjustment is carried out in the following cases:
- during transportation of the implement, buckles shall be blocked to limit the imple-
ment swaying to avoid tractor elements damage in case of an accident;
- during tractor operation with mounted, semi-mounted tilling machines, it is required
to use the adjustment "buckle locked" or 'buckle unlocked" according to the instructions on
the coupled implement (machine) use, provided in the operator's manual.
IT IS FORBIDDEN TO DISPLACE THE LONGITUDINAL AXIS OF THE IMPLE-
MENT IN RELATION TO THE LONGITUDINAL AXIS OF THE TRACTOR BY MEANS OF
BUCKLES ADJUSTMENT.
ATTENTION: THE LENGTH OF RLL LEFT LIFTING ROD MAKES UP 780 MM,
WHICH SHALL NOT BE CHANGED WITHOUT PARTICULAR NEED. USUALLY THE
RIGHT LIFTING ROD CAN BE ADJUSTED ALONG THE LENGTH. WHEN THE LIFTING
ROD IS USED ON THE SUSPENSION AXIS AND WHEN THE REVERSIBLE PLOUGH
IS USED, THE LENGTH OF LIFTING RODS SHALL BE THE SAME!
ATTENTION: NONCOMPLIANCE WITH THE REQUIREMENTS FOR BUCKLES
AND LIFTING RODS ADJUSTMENT MAY RESULT IN BUCKLES OR SUPPORT
BRACKETS ABRUPTION OR OTHER BREAKAGE!
ATTENTION: ESSENTIAL FEATURES AND ADJUSTMENT WAYS OF THE IM-
PLEMENT POSITION COUPLED WITH MOUNTED DEVICES ACCORDING TO THE
PECULIARITIES OF TECHNOLOGICAL PROCESS EXECUTION AND AGROTECHNI-
CAL REQUIREMENTS ARE SPECIFIED IN OPERATIONAL DOCUMENTATION OF
SUCH IMPLEMENTS. IF THERE IS NO SUCH INFORMATION IN OPERATIONAL
DOCUMENTATION, CONTACT THE MANUFACTURER OR SELLER OF THE IMPLE-
MENT FOR INFORMATION!
100
2022.6-0000010 OM