Belarus 2022.6 Operator's Manual page 159

5.4.2.3 Operation 22. Washing of the tractor and cleaning of the cabin interiors
Wash the tractor and clean the cabin inside.
Before washing the tractor with water jet, stop the engine, put the battery disconnect
switch in "OFF" position.
While tractor washing, it is necessary to take steps to protect electric and electronic
components, plugs and sockets against entry of water jets. It is forbidden to direct water jet
onto electric and electronic work-pieces and cable connectors.
IT IS FORBIDDEN TO DIRECT WATER JET TO ELECTRIC AND ELECTRONIC
PARTS, BUNDLED CABLES CONNECTORS.
Maximum water temperature shall not exceed 50
IT IS FORBIDDEN TO ADD CORROSIVE AGENTS (DETERGENTS) INTO WATER
FOR WASHING.
After tractor washing, clean the electric and electronic work-pieces and cable connec-
tors with compressed air.
5.4.2.4 Operation 23. Check of bolt tightening of CAC air duct clamps
Check and if necessary, tighten clamp bolts 1 (figure 5.4.14) of CAC air ducts. Bolt
torque of worm type clamps shall be from 5 to 8 Nm.
ATTENTION: AFTER CHECK OF CLAMP BOLTS TIGHTENING TORQUE, IT IS RE-
QUIRED TO CHECK HERMITICITY OF ALL JOINTS OF CAC DUCT. TO DO THIS, INSPECT
THE JOINTS OF ALL AIR PIPELINES AND SILICONE CONNECTING PIPES OF THE CAC
SYSTEM FOR DAMAGES AND LEAKAGES. IN CASE OF DETECTION ANY FAILURES
AND DAMAGES, IT IS REQUIRED TO FIND OUT THE REASON FOR THEIR APPEARANCE
AND TAKE MEASURES TO ELIMINATE THEM!
IT IS FORBIDDEN TO OPERATE THE TRACTOR WITH THE CAC SYSTEM FAULTY!
5.4.2.5 Operation 24. Check of pneumatic pressure in tires
Value pressure in front and rear tires shall be chosen according to the load per single
tire, driving speed and operations performed. If it is necessary, bring tire pressure to the re-
quired value according to subsection 3.2.8 "Selection of optimal internal pressure in tires, de-
pending on operating conditions and load on tractor axles".
ATTENTION: CONTROL AND BRINGING TIRE INTERNAL PRESSURE TO THE
NORMAL VALUE, WHEN NEEDED, SHALL BE CARRIED OUT EACH TIME THE TRACTOR
CHANGES ONE OPERATION TO ANOTHER AND CHANGES IMPLEMENTS AND MA-
CHINES COUPLED!
5.4.2.6 Operation 25. Drainage of sediment from the fuel tank
To drain sediment from the side fuel tank, it is necessary to do the following:
- screw out tank adapter 1 with screw key S 17 (figure 5.4.16). Tank adapter 1 is lo-
cated at the bottom of fuel tank 2;
- drain sediment until clean fuel appears;
- after clean fuel without water and dirt appears, screw in tank adapter 1.
1 – adapter; 2 – side fuel tank; 3 – coarse fuel filter.
Figure 5.4.16 – Drainage of sediment from the fuel tank
0
С.
159
2022.6-0000010 OM