Adjusting The Torque - Dürkopp Adler D869 e-con Service Instructions Manual

4. Use the other hand to push up with a 3 mm allen key in the threaded
14.2
Fig. 73: Adjusting the torque
(1) - Slot
(2) - Marking point
Proper setting
The machine is set at the factory such that the torque is 8 Nm when the
marking point (2) is exactly above the slot (1) of the washer.
88
pin (1) until the safety release clutch engages with an audible click.

Adjusting the torque

NOTICE
Property damage may occur!
If you change the torque, it could be that the safety release clutch will
not disengage although this would be required.
This could cause machine damage, e.g. in the event of the thread
jamming.
Do NOT change the factory adjustment.
Make sure that the torque remains at 8 Nm.
Adjusting the safety release clutch
① ②
(3) - Screw
Service Instructions D869 e-con - 00.0 - 09/2023
③