Multiplexed Interrupt Sources - Intel 8XC196MC User Manual

When the level-sensitive event is selected, the external interrupt signal must remain asserted for
at least 24 T (24/F
1
XTAL
the level sampler samples the level of the signal three times during a 24 T
valid level occurs, the level sampler generates a a single output pulse. The output pulse generates
the EXTINT interrupt request. The level-sensitive mode is useful in noisy environments, where
a noise spike might cause an unintentional interrupt request.
When an edge-triggered event is selected, the input must remain asserted for at least two T
(2/F ) to be recognized as a valid interrupt. When a valid transition occurs, the transition de-
1
XTAL
tector generates a single output pulse. The output pulse generates the EXTINT interrupt request.
Transition
Detector
EXTINT
Level
Sampler
F
XTAL1
Figure 5-2. Waveform Generator Protection Circuitry
5.3.3

Multiplexed Interrupt Sources

The PI (MD), OVRTM (Mx), and SPI (MH) interrupts have multiple sources (see Table 5-3 on
page 5-5). An individual source will generate the interrupt only if software enables both the in-
terrupt source and multiplexed interrupt. To enable the multiplexed interrupt, set the appropriate
bit in the interrupt mask register (Figures 5-7 and 5-8). To enable an interrupt source, set the ap-
propriate bit in the PI_MASK register (Figure 5-9 on page 5-17). Figure 5-3 shows the flow for
the timer interrupt.
Although the PI interrupt on the 8XC196MC has a single source (the
waveform generator), software must still enable both the source interrupt
(WG) in the PI_PEND register and the PI interrupt in the INT_MASK register.
) to be recognized as a valid interrupt. When the signal is asserted,
1
XTAL
ES, IT
Falling
00
Pulse
Rising
01
Low
10
High
11
NOTE
Get other manuals https://www.bkmanuals.com
STANDARD AND PTS INTERRUPTS
EXTINT
Interrupt
Request
EO Bit
Register
R
S
CPU Write EO
CPU Bus
period. When a
1
XTAL
XTAL
DP
OD#
Q
CPU Read EO
A2661-01
1
5-7