Using The Supply Functions; Setting The Ae Bus Timeout; Setting The Supply Parameters - Advanced Energy Pinnacle 20 kW Manual

Advanced Energy
To find out the software number and version of your system software components, follow
these steps:
1. Press SERVICE → SW_REV.
2. To display the software version of the configuration, press CONFIG.
3. To display the software version of the cards installed in your unit, press CARD.
4. To display the software version of the active panel software, press PANEL.
5. To display the software version of the DSP software, press DSP.
6. To display the software version of the logic, press LOGIC.

USING THE SUPPLY FUNCTIONS

This option lets you modify specific components and parameters of your supply. The menu
options are:
• AEBUS:
• DEFAULTS:
• PANEL:
• PGM_SRC:

Setting the AE Bus Timeout

SUPPLY → AE BUS
To set your AE Bus timeout time, follow these steps:
1. Press SUPPLY → AEBUS.
2. Rotate the MODIFY knob to adjust the AE Bus time out value (in 10 ms increments).
3. Press ENTER to accept and exit.
Note: We recommend you keep this value as small as possible to speed up error recovery due
to noise.

Setting the Supply Parameters

SUPPLY → DEFAULTS
To set all your supply parameters to the defaults and then store them in non-volatile memory,
follow these steps:
1. Press SUPPLY → DEFAULTS.
2. Rotate the MODIFY knob to display Yes or No.
3. Press ENTER to accept and exit.
4-26
Page 60 of 182
®
I/O Communication and Control 5702199-A