Advanced Energy Pinnacle 20 kW Manual page 166

Advanced Energy
Table 7-4. Error Codes
Error Code and
Message
Processor Flash not
Initialized
Watch Dog Expired
(explicit clear)
MAC Reset Off-line
(explicit clear)
Mem Buffer Overflow
Master Released Slave
(explicit clear)
Error Codes 70 through 79 are internal errors in the unit's logic card microprocessor.
Divide by 0
Single Step
Breakpoint
Overflow
Array Bound
Opcode Error
7-12
Page 166 of 182
®
Problem Indicated
E030 Flash memory was not
initialized properly.
Error Codes E51 through E69 refer to Profibus interface errors.
E051 The Profibus master stopped
talking to the Pinnacle supply
after establishing
communications.
E054 The unit's SPC (Profibus
Controller) has taken itself
"off-line," probably in
response to another error
E055 The Profibus communication
has overflowed the buffer.
E059 The Profibus master has
stopped communicating with
the Pinnacle unit using the
proper protocol. This "slave"
is now available to be
"owned" by another master.
If output is on, the Pinnacle
unit turns output off.
E070 Internal software error.
E071 Internal software error.
E072 Internal software error.
E073 Internal software error.
E074 Internal software error.
E075 Internal software error.
Troubleshooting and Customer Support
Suggested Action
Call AE Global Support.
Have the master re-establish
communications and send a
"master reset" to clear the
Pinnacle unit's display.
Cycle the Pinnacle unit's
power off and on and re-
establish communications
between the master and slave.
Increase the time between
packets being sent to the unit
via the Profibus master.
To recover from the "off
state," have a Profibus master
establish communication with
the Pinnacle unit and send a
"master reset" to clear the
Pinnacle unit's display.
Call AE Global Support.
Call AE Global Support.
Call AE Global Support.
Call AE Global Support.
Call AE Global Support.
Call AE Global Support.
5702199-A