Pinnacle™ 20 kW
4 A two-byte hex representation of the software options appears.
Checking Your ROM
SERVICE → MEMORY
To perform ROM cyclic redundancy check (CRC) checking:
Note: There is a momentary delay before the CRC will display.
Note: Not all cards support this option.
1. Press SERVICE → MEMORY → ROM → CARD.
2. To calculate and display the active panel (local or remote) CRC, press PANEL.
3. To calculate and display the DSP CRC, press DSP.
4. To calculate and display the logic board CRC, press LOGIC.
Checking Your Software Versions
SERVICE → SW_REV
To find out the software number and version of your system software
components:
1. Press SERVICE → SW_REV.
2. To display the software version of the configuration, press CONFIG.
3. To display the software version of the cards installed in your unit, press CARD.
4. To display the software version of the active panel software, press PANEL.
5. To display the software version of the DSP software, press DSP.
6. To display the software version of the logic, press LOGIC.
USING THE SUPPLY FUNCTIONS
This option lets you modify specific components and parameters of your supply. The
menu options are:
• AEBUS:
• DEFAULTS:
• PANEL:
• PGM_SRC:
5702156-E
I/O Communication and Control
4-27