Leds; Active Front Panel/ Pinnacle Remote Panel; Table 4-8. Display Panel Leds - Advanced Energy Pinnacle 20 kW Manual

LEDs

Table 4-8. Display Panel LEDs

POWER ON
OUTPUT
SETPOINT
INTERLOCK
BUS FAULT
OVERTEMP
ARC

ACTIVE FRONT PANEL/ PINNACLE REMOTE PANEL

The Pinnacle supply presents a broad array of features and settings that you can easily control
through the Active Front Panel or the Pinnacle Remote Active Panel. If you are using the
Pinnacle Remote Active Panel, first ensure that it has been properly connected to the Pinnacle
supply; installation information appears in the following section.
Note: The master/slave functions listed in this section apply only to Pinnacle supplies with a
master/slave Host card installed.
5702199-A
Page 47 of 182
Lights green when input power is on
Lights green if output power is on
Lights green if the Pinnacle supply is operating within
setpoint:
• For a stand-alone unit, accuracy is within 0.4% of full
scale or 2% of setpoint, whichever is greater.
• For master/slave systems, setpoint range is 3.125% of
the full scale of the system.
Note: The master of a master/slave system is also
constrained by the stand-alone out-of-setpoint
limit. This limit (0.4% of full scale or 2.0% of
setpoint) only applies to the output of the master
in the system.
Lights green if all interlock conditions have been met
Lights green when a bus fault occurs
Lights green if the Pinnacle supply has exceeded the
maximum operating temperature
After the output has been turned off, this LED lights green
for a predetermined time (normally 100 ms) if the hard arc
count limit was reached or exceeded during the previous
run. If your unit has been configured for signaling on every
hard arc, this LED will blip for a predetermined time for
every hard arc detected by the unit. If another hard arc is
detected before the last blip is complete, the blip pulse
width will be refreshed to the full width.
I/O Communication and Control
Pinnacle™ 20 kW
4-13