Passive Display Panel; Display; Table 4-7. Passive Display Panel Codes - Advanced Energy Pinnacle 20 kW Manual

Advanced Energy

PASSIVE DISPLAY PANEL

The passive front panel and remote passive panel let you monitor power, current, or voltage;
receive error codes; and review several other conditions shown by the LEDs.
Note: The master/slave functions listed in this section apply only to Pinnacle supplies with a
master/slave Host card installed.

Display

At any time while the Pinnacle supply is operating, you can press the DISPLAY buttons to the
left of the four-digit display to find the number of kilowatts (or watts), volts, or amps being
delivered.
This display also shows error codes when a fault or software error has occurred. For a detailed
explanation of these codes and other troubleshooting materials, see the "Troubleshooting"
chapter.
When only a Passive Front Panel (PFP) is available, the Pinnacle unit will display 4 character
strings on start up to identify personality cards installed in the unit. A code will flash once for
each card installed. The following table describes the strings:

Table 4-7. Passive Display Panel Codes

PFP Display String
H----
H-01
H-03
H-04
H-05
H-18
H-22
H-23
H-30
4-12
Page 46 of 182
®
No Cards
Dual User Card
Profibus Card
Host Protocol Translator Card
Single User Card
AE Bus Card
Master/Slave Card
DeviceNet
DeviceNet
I/O Communication and Control
Personality Card
5702199-A