Checking Your Hardware Configuration; Checking Your Communications Card; Checking Your Software Logic; Checking Your Rom - Advanced Energy Pinnacle 20 kW Manual

CHECKING YOUR HARDWARE CONFIGURATION

SERVICE → DEBUG → HW CONFIG
To find out whether or not a card is installed in slot 1 or 2:
Press SERVICE → DEBUG → HW CONFIG.
A report of the personality cards installed in the supply in slot 1 and slot 2 appears.

CHECKING YOUR COMMUNICATIONS CARD

SERVICE → DEBUG → CARD
Use this option to find out specific communications debug information:
Press SERVICE → DEBUG → CARD.
Note: Not all cards support this feature.

CHECKING YOUR SOFTWARE LOGIC

SERVICE → DEBUG → LOGIC
Use this option to find out what software logic options are installed.
Press SERVICE → DEBUG → LOGIC.
A two-byte hex representation of the software options appears.

Checking Your ROM

SERVICE → MEMORY
To perform ROM cyclic redundancy check (CRC) checking, follow these steps:
Note: There is a momentary delay before the CRC will display.
Note: Not all cards support this option.
1. Press SERVICE → MEMORY → ROM → CARD.
2. To calculate and display the active panel (local or remote) CRC, press PANEL.
3. To calculate and display the DSP CRC, press DSP.
4. To calculate and display the logic board CRC, press LOGIC.

Checking Your Software Versions

SERVICE → SW_REV
5702199-A
Page 59 of 182
I/O Communication and Control
Pinnacle™ 20 kW
4-25