Passive Display Panel Codes; Table 7-2. Passive Display Panel Codes - Advanced Energy Pinnacle 20 kW Manual

Table 7-1. Help Codes
Help Code
H021
Ramp Parameters Out
Of Range
H080
Configured as Slave
Unit
H099
AEBus: Command Not
Implemented

Passive Display Panel Codes

When only a Passive Front Panel (PFP) is available, the Pinnacle unit will display 4 character
strings on start up to identify personality cards installed in the unit. A code will flash once for
each card installed. The following table describes the strings:

Table 7-2. Passive Display Panel Codes

PFP Display String
H----
H-01
H-03
H-04
H-05
H-18
H-22
H-30
5702199-A
Page 159 of 182
Problem Indicated
The output could not ramp
to the requested setpoint.
however, the output is ON.
The action requested could
not be performed because
the unit is configured as a
slave.
The command sent via
AE Bus is not recognized by
the unit.
No Cards
Dual User Card
Profibus Card
Host Protocol Translator Card
Single User Card
AE Bus Card
Master/Slave Card
DeviceNet
Troubleshooting and Customer Support
Pinnacle™ 20 kW
Suggested Action
Adjust the ramp parameters.
No action.
Review the AE Bus
commands.
Personality Card
7-5