Advanced Energy Pinnacle 20 kW Manual page 117

Table 4-18. Host Port Commands
Command
182
request recipe
step setpoint
and
regulation
mode
183
request recipe
step run time
184
request out-
of-setpoint
interval
185
request TCC
timer
187
request out-
of-setpoint
timer
5702199-A
Page 117 of 182
Description
Requests the setpoint level you have set
for a specific ramping recipe step set with
Command 22. Send 1 data byte (8-bit
value) indicating the recipe step. The
returning packet contains 3 data bytes:
• first and second bytes = value of
setpoint in the mode indicated
• third byte = regulation mode (6 =
power; 7 = voltage; 8 = current)
Requests the run time you have set for a
specific recipe step set with Command
23. Send 1 data byte (8-bit value)
indicating the recipe step. The returning
packet contains 2 data bytes indicating
the run time in seconds. Two decimal
places are implied. For example, a value
of 5 would indicate 0.05 s.
Requests the amount of time remaining
on the out-of-setpoint timer before an
error condition occurs; the returning
packet contains 2 data bytes (16-bit
value) indicating the interval value in
seconds. One decimal place is implied.
For example a value of 999 would
indicate an interval of 99.9 s.
Requests the acceptable idle time set with
Command 80; the returning packet
contains 1 data byte (8-bit value)
indicating the idle time in seconds.
Requests the out-of-setpoint timer value
set with Command 31; the returning
packet contains 2 data bytes (16-bit
value) indicating the timer value in
seconds. One decimal place is implied.
For example, a value of 999 would
indicate a timer value of 99.9 s.
I/O Communication and Control
Pinnacle™ 20 kW
Number of Number of
Transmit Response
Data Bytes Data Bytes
1 3
1 2
0 2
0 1
0 2
4-83