External Dips; Figure 4-12. Rocker Dip Switch (Internally Located On A Master/Slave Interface Card); Figure 4-13. Slide Dip Switch (Externally Located On Units Without A Master/Slave Card) - Advanced Energy Pinnacle 20 kW Manual

switch to the "down" position means setting it away from the numbers. On "rocker" DIPs,
"up" means that the side of the switch toward the numbers is depressed. On "slide" DIPs, "up"
means that the slide is pushed toward the numbers.

Figure 4-12. Rocker DIP switch (internally located on a master/slave interface card)

Figure 4-13. Slide DIP switch (externally located on units without a master/slave card)

EXTERNAL DIPS

On units where the DIP switch is located externally on the rear panel, it can be difficult to see
the numbers, and the orientation of the unit may change. However, the orientation of the DIP is
always the same relative to the unit and, when the unit is sitting right side up, the numbers are
at the top of the DIP. The following illustration shows the orientation of the Host port and DIP
switch on the back panel of the Pinnacle supply.
5702199-A
Page 79 of 182
I/O Communication and Control
Pinnacle™ 20 kW
4-45