Passive Display Panel Codes; Passive Display Panel Help Codes - Advanced Energy Pinnacle User Manual

Pinnacle™ 20 kW
Table 7-1. Active Panel Display Help Codes (Continued)
Help Code
Recipes Enabled
User port STANDBY.D
Ramp Parameters
Out-Of-Range
Configured as Slave Unit
AEBus: Command Not
Implemented

Passive Display Panel Codes

When only a Passive Front Panel (PFP) is available, the Pinnacle unit will display 4
character strings on start up to identify personality cards installed in the unit. A code
will flash once for each card installed. The following table describes the strings:
Table 7-2. Passive Display Panel Help Codes
PFP Display String
5702156-E
Problem Indicated
H019 The requested action
could not be performed
because the recipe
feature is enabled.
H020 The STANDBY.D line
on the User port has
is active been asserted.
H021 The output could not
ramp to the requested
setpoint. however, the
output is ON.
H080 The action requested
could not be performed
because the unit is
configured as a slave.
H099 The command sent via
AE Bus is not
recognized by the unit.
H----
H-01
H-03
H-04
H-05
H-18
H-22
H-30
Troubleshooting and Customer Support
Suggested Action
TCC, Ramp, and
Recipe features are
mutually exclusive.
Disable the Recipe
feature and repeat the
action.
Review user port
functionality and
assert/de-assert
STANDBY.D as needed.
Adjust the ramp
parameters.
No action.
Review the AE Bus
commands.
Personality Card
No cards
Dual User card
PROFIBUS card
Host Protocol Translator card
Single User card
AE Bus card
Master/Slave card
DeviceNet
7-5