Icom IP1000C Instruction Manual page 64

4
ABOUT THE SETTING SCREEN
4. [Network Settings] Menu
■ IP Address
Enter the IP1000C's IP Address.
1
2
3
4
5
IP Address �������
1
Subnet Mask ������
2
Default Gateway �����
3
Primary DNS server ���
4
Secondary DNS server ��
5
<Apply> ��������
6
<Reset> ��������
7
Enter the LAN IP address according to your network environment.
L When using the DHCP Server function, the network part of the IP address
must be the same as that set in the "IP Pool Start Address" item in the
[DHCP Server] menu. (p. 4-12)
Enter the subnet mask according to your network environment.
If a default gateway device (such as a router) is connected to the LAN
port, enter the device's IP address.
Enter the DNS server address specified by your service provider.
If you have two DNS server addresses, enter the primary address.
Enter the secondary DNS server address, if you have two DNS server
addresses.
Click to apply the entries.
Click restore the settings.
L You cannot restore after clicking <Apply>.
4-11
[Network Settings]–[IP Address]
6 7
(Default: 192.168.0.1)
(Default: 255.255.255.0)