Icom IP1000C Instruction Manual page 53

3
OTHER BASIC FUNCTIONS
3. Using the DHCP function
You can use the DHCP function by following the procedures below.
■ Setting example
Click the [Network Settings] menu, then [DHCP Server].
1
• The [DHCP Server] screen appears.
Select "Enable" in the "DHCP Server" item, and then click <Apply>.
2
Enter the new IP pool start address and so on, depending on your requirement, and then click <Apply>.
L The factory default of this setting is "Disable."
Click <Reboot>.
3
• When you are asked to reboot the IP1000C, follow the instructions.
About the DHCP server function
The IP1000C's DHCP server function is disabled as default.
L Before changing this function to "Enable," make sure that the addresses of the devices on the network do not overlap
or conflict.
If a DHCP server is already connected to the network, and there is an address conflict, a network problem will occur.
See the Troubleshooting section for possible solutions.
About the maximum number of the IP addresses
Up to 128 addresses can be automatically assigned by the DHCP server function.
Another 32 addresses can be manually assigned.
Click
3-4
q Click
w Enter
e Click