Installing The Reichle Masari Cross-Connect Terminal (Germany) - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Installing the Reichle Masari cross-connect terminal
(Germany)
Installing and connecting cross-connect terminals
Procedure 37 describes how to install the Reichle Masari cross-connect
terminal for Germany.
Procedure 37

Installing the Reichle Masari cross-connect terminal (Germany)

1 Consult the equipment layout plan to determine where to place the
cross-connect terminal. Refer to the system and site requirements
Small System: Planning and Engineering (553-3011-120)
chapters in
2 Install the terminal blocks in a layout similar to that shown:
• in Figure 97 on
• in Figure 97 on
3 Attach labels on the cross-connect terminal to indicate the terminal blocks
assigned to the following:
• 25-pair cables from the cabinets or chassis
• AUX wiring
• Power Failure Transfer Units (PFTU)
• Telephones and consoles
• Trunks
• Analog line cards
• DC5/AC15/RAN/PAG cards
• Data Access Cards
• Digital line cards
• Exchange line trunk cards
• Direct Dialing Inward trunk cards
• other miscellaneous equipment
4 For the Cabinet system: Ground the cross-connect terminal.
page 242 for the Cabinet system
page 242 for the Chassis system
Small System
Page 241 of 562
Installation and Configuration
.