Nortel Meridian 1 Succession 1000M Installation And Configuration Manual page 146

Page 146 of 562
553-3011-210 Standard 1.00
Connecting the chassis expander to the chassis
Procedure 11
Adding a chassis expander
1 Install the chassis expander following the procedures in "Mounting the
chassis" on page
2 Connect one of the NTDK95 cables from the CE-MUX connector on the
back of the chassis to the CE-MUX connector on the back of the chassis
expander.
3 Tighten the screws on the connectors.
4 Connect the other NTDK95 cable from the DS-30X connector on the back
of the chassis to the DS-30X connector on the back of the chassis
expander.
5 Tighten the screws on the connectors.
Note: The expansion cable kit (NTDK89) contains two NTDK95 cables.
Figure 52 on page 147
connected with the two NTDK95 cables.
October 2003
125.
shows the chassis and chassis expander