Nortel Meridian 1 Succession 1000M Installation And Configuration Manual page 325

7 Update the ELAN configuration. Enter the following command:
UPDATE DBS
8 Reboot the main cabinet or chassis for the changes to take effect or go
into LD 137 and disable and enable the ELNK. Enter the following
commands:
DIS ELNK
ENL ELNK
Procedure 52
Configuring the ELAN IP address for the Small System active ELNK
Ethernet interface for an IP expansion cabinet or chassis
1 Go into LD 117.
2 Create host entries with IP address on the ELAN subnet. Enter the
following command:
NEW HOST <hostname> <IP_addr> <cab#>
Where:
<cab#> = 1–4, for the IP expansion cabinet or chassis
3 Configure the ELAN Mask. Enter the following command:
CHG MASK <maskvalue> <cab#>
Where:
<maskvalue> = xxx.xxx.xxx
<cab#> = 0, for the main cabinet or chassis
4 Configure a new Routing Entry. Enter the following command:
NEW ROUTE <destination IP> <gateway IP> <cab#> <port#>
Where:
<destination IP> is the ELAN IP address of IP Line card on the IP
expansion cabinet or chassis
<gateway IP> is the ELAN IP address of the IP expansion cabinet or
chassis
<cab#> = 1–4 for IP expansion cabinets or chassis
<port#> = 0 for 10BaseT
To configure IP Line for other IP expansion cabinets or chassis, repeat
steps 1–4.
5 Verify your IP address for the Ethernet. Enter the following command:
IP Line card configuration
End of Procedure
Small System Installation and Configuration
Page 325 of 562