Connecting The Chassis Expander; To The Chassis; Contents; Introduction - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Connecting the chassis expander

to the chassis

Contents

Introduction

Adding a chassis expander

This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Adding a chassis expander . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
This chapter describes how to add a chassis expander to your Chassis system.
Use the same methods described in "Mounting the chassis" on
install the chassis expander. Refer to the chapter on developing an equipment
layout plan in Small System: Planning and Engineering (553-3011-120) for
measurements and distances between the chassis and the chassis expander.
This chapter contains the following procedure:
• Procedure 11: "Adding a chassis expander" on
The chassis expander connects to the chassis by two copper cables: one
provides DS-30X connectivity and the other provides CE-MUX connectivity
to slot 10 only.
Small System Installation and Configuration
Page 145 of 562
page 125
page 146
145
145
to