Nortel Meridian 1 Succession 1000M Installation And Configuration Manual page 194

Page 194 of 562
553-3011-210 Standard 1.00
Installing Small System Controller and Fiber Receiver cards
3 Replace the standoffs on the SSC card with the taller standoffs supplied
with the IP daughterboard.
4 Record the MAC address found on the back of the daughterboard. This
will be needed later to perform the software installation. See Figure 75 on
page 196.
5 Insert the male end on the NTDK8305 cable into one port on the IP
daughterboard. Pull gently on the cable to make sure the connection is
secure.
Note: The top connector on the SSC card is for expansion cabinets or
chassis "1" and "3". The lower connector is for expansion cabinets or
chassis "2" and "4".
6 Connect the LED cable to receptacle on daughterboard. See Figure 75 on
page 196 for exact location.
7 Mount daughterboard onto card by inserting the plastic post into
designated slot on the daughterboard. See Figure 75 on
exact positioning.
Note: Tip daughterboard down over the post and press down onto the
two standoffs.
8 Firmly press daughterboard down on connector pin to secure in place.
9 Route expansion cable through the cable router on the SSC card.
10 Install EMC grounding clip.
For the Cabinet system, the EMC grounding clip is mounted on the
cabinet's stiffener rail. See Figure 76 on
For the Chassis system, the EMC grounding clip is mounted on the fan
baffle on the lower right-hand side of the chassis. See Figure 77 on
page 198 for exact positioning.
Note: Depending on the vintage of the cabinet, this clip may already be
installed. In this case, loosen the screws that secure it to the stiffener rail
and rotate the clip to an outward position.
CAUTION WITH ESDS DEVICES
The EMC grounding clip must be used to secure the
contact between the cable and the metal stiffener rail.
Failure to do so will compromise EMC compliance.
October 2003
page 196
page 197 for exact positioning.
for